Review: Stilletto titanium nail puller

I do love a  good salvage. Whether it be road-side junk-swap, flea market bargain or dump-harvest the idea of junk salvage strikes a deep chord in me from both a 

post-apocalypse survivor point of view  and 80's kids sci-fi. That said, sometimes having the right tool for the job, especially if you're working with aged or non standard materials. I do like to recycle timber, for garden-beds and storage shelf construction, and getting the nails out can sometimes be a real pain, especially in well seasoned hardwood pallets.  

Previously I have made do with my pair of  demolition hammers (the Dead-On Annihilator and the Stanley Fat-MAX FUBAR) which are brute force tools, even when paired with pry tools such as Jimmy and the ever rugged Breacher bar. I've had a lot of success with this combination of tools but they're inelegant. I'm also a sucker for titanium. I know its not a miracle metal, neither mithril nor vibranium/ adamantium but its pretty rad.

Now on to the tool!

This is the original Stiletto Titanium framing nail puller with the Patented nail removal feature! In essence it is a 30.48cm ( 11.5") pry bar, made of one piece of titanium. It has an open-truss design to cut weight but retain rigidity, weighing in at 300g (8.5 Oz)

One end features a standard cloven hoof pry edge, which is quite pointy, for aggressive purchase finding, and the other end its a cat's paw, 90 degree pry bar, with a similarly pointy tined  cloven end, and a smooth, rounded fulcrum for mark-free nail-pulling. The key feature of the cats-paw end is the perpendicular dimpler. This open-ended conical protrusion is used to punch a circular indentation into the wood,below the level of the head of the nail, in order to allow either of the pry ends to find purchase and pull them out. This is achieved by centering the open end of the dimpler around the had of the nail and striking the back face with a hammer, hard enough to drive a dimple into the wood around the nail-head. 

The dimpler has an internal diameter of 1cm (0.4") which should be plenty big enough for common nails found in timber. Stiletto specifically state it be used for "common nails" only

 

The divot allows the tines of the nail pullers to be worked under the nail-head without gouging the wood too much ( divot aside). I found that for especially stubborn or embedded nails ( or punched down, or otherwise deep) that the tines can be driven in by hammering in the tool from the other end. It should be worth noting that Stilleto claim the titanium strike faces outlast steel bars 3X longer - doesn't spall, crack & mushroom like steel bars. I also use the back face of the cats-paw to drive some nails, and though it took some transfer marks, the satin matte finish was un-marred. It's a bit light to act as a hammer effectively but in a pinch, just fine. 

The open truss body is clean edged and smooth to the hand, allowing a strong grip be taken without roughing up your hand.

The shaft of the tool is slim enough to be threaded through PALS/MOLLE channels, for belt, pack or carrier  carry, but I wnt through my leather scraps bag and whipped up a quick holster with a belt loop for my use. I look forward to easy break-down of pallets and furniture for firewood or lumber needs.

Its a great tool, multi-functional, rugged and fit for purpose.