Review: Gardening shovel

Another hand tool post. I really like hand tools, not only because of their simple utility and ease of use but also on the freedom from reliance on power, for both off-grid use and grid-gone use.

Digging holes is one of those truly universal skills that all peoples; Inuit to Bedouin, Pict to Massai participate in. There is something very primal about digging. Whether is be digging up roots and tubers, clam or crabs for food, digging a fire-pit like a Dakota fire-hole ,digging for fresh water, for shelter or to bury a cache of booty. 

This most recent tool i've added to my arsenal is this very simple gardening trowel I saw online. 

This tool is simplicity itself. An overall length of 32cm (12 1/2"), half of which is "blade" the other half is handle. Made from a single piece of 16Ga stainless steel 2.2cm (7/8th") tubing, the blade has been punched out and folded outwards to a nominal width of 5cm (2")) The resulting edge is unsharpened, but finishes in a respectable point. 

The tip is slightly canted inwards almost to the centre of the handles cross-section, for scooping and balance.

The whole tool has been dip-coated in a tough black paint, which has barely worn on the edges from my digging in sandy soil and repeated throwing into turf and fence posts. 

The butt-end of the pipe handle is filled with a hard plastic plug that I managed to pry off, drill a hole into and add a cord loop for ease of removal and grabbing.

A quick dirt test resulted in a slightly lower yield  than the ChinLin spade but what it misses in surface area it makes up for in depth and low-drag design, which results in a quick digging tool. 

Silent and efficient this tool allows you to dig deep, even through tough turf, perfect for planting bulbs or seedlings. The most exciting part of this tool is that the hollow pipe handle doubles as an eye for mounting a shaft which can either add reach for digging or weeding without tedious bending. 

It is completely and totally coincidental that fitting it to a standard broom handle converts it into a fairly serviceable spear. Much like the humble axe, a spear is a force multiplier and unmatched in melee combat, even in the hands of relatively unskilled operators. 

Weighing in at a mere 120 gm (4 1/4 oz), this tool is easy on the hand and deft in the garden. The only drawbacks are the open end on the blade/ handle interface allowing dirt to enter, but not a  significant issue, a quick shake or bang will loosen that. In a pinch you could scoop up water and carry it in the upturned handle. 

Review: ChinLin spade trowel

NOTE: rebranded but looks the same here: https://www.aussiestormshop.com.au/clearance-mini-hand-shovel-trowel-with-7-functions

Whether it's putting in crops, digging up a secret-squirrel cache, taking care of some business in a back-woods latrine or just some old fashioned fox-hole digging, having  a good digging tool comes in very handy and saves the old fingernails. I have a couple of folding entrenching tools in my camping/bug out kits, but even compact as they are, they can add a bit of bulk and weight. Sometimes they're even a bit too much tool for the job. A full-sized e-tool will make a big Dakota-fire hole, where a trowel sized tool would be more economical. I love multi-function tools, especially when they don't add function at the expense of the primary function. 

This little beauty is the ChinLin HW-901 spade and I originally picked a couple up on Wish.com but it looks like they are no longer sold there. I did find them on this Indonesian clone ( buyer beware). What it is is a 26.3cm ( 10 1/3") trowel with a para-cord wrapped box handle. Made from a  single piece of 420 Stainless steel, the handle has been welded along the middle of the upper face, obscured by the cord wrap. The trowel has a sharpened edge around 3/4 of its edge, with the final quarter being a serrated saw-edge. The spoon face of the tool has a nail puller cut in as well as a set of four hex-head wrench cut-outs. 

The edges aren't super-sharp but they're sturdy enough to chop with, which will be good for clearing brush, weeds or stubborn roots whilst digging. Weighing in at only 80g (2.8oz) it's not going to cut it as an axe, but it makes for a lively and light digging tool. The sharp edges and serrations do make digging through turf easy, and the tool-cut-outs don't effect digging and scooping output significantly.

There is a 7cm ruler printed on the inside of the spoon which is  a nice addition. The pressed steel has a spine ridge pressed in for stability and the tool is very stiff, which makes it very good when sawing or prying (splitting cracked wood or perhaps stone), especially handy when pulling nails with the nail puller or applying torque with the hex wrench holes. 

The cord-wrap is made of 290cm (9'6") of paracord, secured to the handle through four sets of holes drilled into the sides of the handle, and terminating in a lanyard loop at the bottom end. The handle has a slight taper which keeps the cord from sliding off either ends. 

Those side lashing holes and the hole in the spine of the spoon near the handle of the tool can also act as attachment points to fix a pole fitted into the hollow handle, either acting as a extension to the handle, or to turn the tool into a spear. 

The tool comes in a hand if pretty flimsy nylon pouch with a belt loop. I've found it very useful to have on hand when picnicking or hiking. The pouch keeps the sharp edges secure. 

I bought one for myself as a tactical hand shovel, and another for my veggie-garden planting partner. We've both put it to  good use and they've never failed us. 

Panjang Handle: 10.4 cm

Reblogging: Improvised Tanks for Tank Week

Here's a piece I wrote for Breach Bang & Clear

“Every normal man must be tempted, at times, to spit on his hands, hoist the black flag, and begin slitting throats.” ― H.L. Mencken, Prejudices: First Series

... and at times you want more than just a mean look and the occasional sandbag to be between you and harms way. Sometimes you want to call on the thunder of armour. However, you might not have the power of the military-industrial complex behind you. You might only have the local scrapyard, oxy-torches, sheet metal, and an innovative spirit.

Currently the world's undersupplied warfighters are inventing all kinds of home-brew armour options, and we've been lucky enough to catch a glimpse of them over the last few years. And I must say, we're lucky to have only been catching glimpses and not rolling into battle in them. Let's check a few out.

 

This is the SHAM II, a proudly "100 percent made in Syria" improvised armored vehicle. Put together by Syrian rebels of the Al-Ansar brigade, in Bishqatin, four kms west of Aleppo, it came to the world's attention on December 8, 2012.

Built on an old car chassis and covered in 25mm thick steel walls, it was reportedly able to resist up to 23mm cannon fire. At only 2m wide and 4m long, this is no Abrams. It is, however, fitted with a remote-operated (by a hotwired Playstation remote of all things) 7.62mm machine gun on top. It also has five cameras that give the humans inside a view from all angles.

In one of the original interviews, its primary operator said ‘This is my brother, a trained engineer, who got the idea, we got a car, left its diesel motor on the chassis and built the engine. Not including from the gun, the vehicle costs about £6,200($10,000)." This gives you an understanding of what these folks are doing with their spare time.

Read the rest here at Breach Bang & Clear: