Tuesday, August 13, 2019

Review: ITW - Tac-Toggle

Continuing on my theme of cordage, I bring you the ITW Tac-Toggle. Toggles being one of the more ancient button options available to us it'as no surprise that the sharp eyes and nimble hands behind ITW have taken it from antler-tip, bone and stick into the realms of ballistic nylon.

So, what is it? A taper ended cylinder, with moulded-in notches and two holes in a recessed channel. All up it's just 1 1/2" (40mm) long and 6mm x 8mm thick. The holes are sized to accommodate paracord, but it's a snug fit and I found that melting a cut end to taper it to facilitate feeding it through. Thinner cord feeds without any issue and can even be pinched and fed through as a loop to fit to a strung line "on the bight".

As a line ending stopper on paracord, it's just a matter of feeding the line through both holes and feeding it back into itself.  This forms a very sturdy lock and uses very little cord, less than a stopper-knot for sure. The looped cord lays in the recess and holds the toggle perpendicular to the cord. 

As a stopper, the perpendicular end-knot only makes a sturdy gripping point between the fingers held in a fist, but also as an anchor. The width of the Toggle makes it very suitable for holding items in place through PALS/MOLLE channels. Feeding it in is as simple as turning the toggle 90 degrees and slipping it down through the channels. It is snag free and quick to deploy and detach whilst simultaneously being a sturdy attachment system without needing to tie paracord into the MOLLE directly.
Another way to feed cord into the two holes not as a stopper but along its length, such that the toggle lays parallel along the line and sits in place allowing the toggle to act as a hitching point for other lengths of cord. Pulling a length of line through the holes gives you loop of cord to hang things off, a series of these would give you a daisy chain of attachment points for all manner of gear. 

Simply having a toggle at the end of a line can also enhance the pull capability of cordage, with an improved grip on a toggle between the fingers over a knot or just bare cord. good for dressing lashings, hauling loads or compressing bundles. 


So, as well as securing things to to PALS/MOLLE  and acting as a tie-off point or tensioner on  guy line, I use one of the toggles to secure my wallet. I run a length of paracord from my  Hazard 4 Loader harness and have previously just used a stopper knot to secure it through a hole in the middle of the bill-fold section. I replaced the stopper knot with a Tac-Toggle and my wallet has neither slipped loose nor become dislodged. It also means I have a spare toggle in my EDC in case I need to work some cordage. It also wouldn't look out of place

All in all for a small piece of kit I'm impressed. It brings form and function, and the simple elegance of an ancient device in a modern format it brings  a lot to the table.

Fit two and you've got anchorage for a bow drill, or grips for hauling a sled up a hill. Fit one to a line and feed through a button hole for an unobtrusive  "deep carry" for a SERE kit like the Oscar Delta SPD




No comments:

Post a Comment

Related Posts Plugin for WordPress, Blogger...